Router Table Project – Drawers

.The bottom section of the table is going to have a drawer and I cut the front, back, and sides to the correct dimensions. Cut a small rabbet near the bottom edge of all those pieces in order to slide a 1/4 inch sheet of plywood for the drawer bottom. Glued all the sides together with the bottom in place.

Next I edge joined two pieces of 3/4 inch red oak together to make the drawer front. Added drawer slides to the side and mounted the front fascia in place.

Going to work on the permanent drawer pull and adding doors above the drawer.  

 

Leave a Reply

Your email address will not be published. Required fields are marked *